Flat Roof Repair & Replacement in New Jersey

Flat and low-slope roofs done in the right membrane for the job: EPDM, TPO and modified bitumen, installed and repaired to stay dry.

Call now(201) 908-0002
Overview

Flat roof repair and replacement in NJ

Flat and low-slope roofs do not shed water the way a pitched roof does. They rely entirely on a continuous, watertight membrane. When that membrane is punctured, shrinks or fails at a seam, water sits and finds its way in. The same is true on the commercial buildings we work on.

We repair and replace flat roofs on homes, additions, porches and garages across New Jersey, working in EPDM rubber, TPO and modified bitumen. Flat roofs are most of what we see in Hoboken and Jersey City. We match the system to the roof, the budget and how long you need it to last.

Ponding water is the enemy of every flat roof. Water that sits more than about 48 hours after rain breaks the membrane down faster and voids most manufacturer warranties. It usually means a drain, scupper or gutter is blocked, or the deck has settled out of pitch. Flat roof drainage fixes range from clearing and resetting a drain to adding tapered insulation so the water runs where it should.

Not every flat roof needs a new membrane. EPDM repair on a rubber roof with a few open seams or punctures is quick work, and a sound but tired roof can often take a flat roof coating that adds years for a fraction of the cost of replacement. Torch-down modified bitumen is repaired with new plies heat-welded over the damage. When the membrane is brittle or the insulation under it is wet, flat roof replacement is the honest answer. Our guide to flat roof maintenance in NJ covers what you can check yourself.

What's included

EPDM, TPO, torch-down and flat roof coatings

  • EPDM rubber roofingDurable single-ply rubber roof membrane, a proven, cost-effective choice for residential flat roofs and quick to repair.
  • TPO membrane roofingHeat-welded reflective TPO seams for a bright, energy-efficient, watertight surface.
  • Modified bitumen & torch-downMulti-layer torch-down or self-adhered bitumen systems for tough, walkable low-slope roofs.
  • Leak repair & ponding fixesSeam, puncture and flashing repairs, plus drainage corrections where water is ponding.
  • Flat roof coatingsReflective elastomeric coatings that extend a sound, aging roof by years for a fraction of replacement cost.
  • Drains, scuppers & parapetsClogged drains cleared, scuppers and parapet flashing rebuilt, and slope corrected so water leaves the roof.
How it works

How a flat roof job runs

  1. 01

    Survey

    We inspect the membrane, seams, flashings and drainage to find why the roof is failing.

  2. 02

    System recommendation

    You get a clear comparison of EPDM, TPO and bitumen for your specific roof and budget.

  3. 03

    Installation

    Old membrane removed where needed, the deck prepped, and the new system installed to spec.

  4. 04

    Water test & guarantee

    We confirm the roof drains and stays dry, backed by our workmanship guarantee.

Warning signs

Signs your flat roof needs repair

  • Pooled or ponding water that lingers days after rain
  • Bubbles, blisters or wrinkles in the membrane
  • Cracked, lifted or separated seams
  • Interior leaks below a flat section, porch or addition
  • A membrane that is brittle, shrinking or 15+ years old
When to call us

Spotting these signs? Get a flat roof repair estimate before it gets worse.

Where we work

Where we do flat roof repair in NJ

From our Englewood headquarters we work across 12 New Jersey counties. Pick yours for local housing, weather and permit notes.

All service areas
Roof estimate

Need flat roof repair in New Jersey?Get a fixed-price estimate from a licensed local roofer, no obligation.

FAQ

Flat roof repair in NJ: common questions

It depends on the roof. TPO is a white, heat-welded membrane that reflects heat and suits sunny roofs over living space; EPDM is black rubber that is durable, economical and easy to repair. Modified bitumen is the tough, walkable choice for roofs with foot traffic. We recommend based on your roof and how you use it.
Because the slope or the drainage has failed. Flat roofs are built with a slight pitch toward drains, scuppers or gutters, and pooling usually means a drain is partly blocked or the deck has sagged. Water that sits more than 48 hours after rain shortens the life of the membrane, so it is worth fixing the cause.
Coat it if the roof is sound and just tired; replace it if it is wet or widely failing. A coating on a dry, structurally sound membrane can add 8–12 years for roughly 30% of the cost of replacement. On a roof with wet insulation, several active leaks or a damaged deck, a coating is just paint on a bad surface.
Isolated seam and puncture leaks are often repairable. If the membrane is brittle, shrinking or widely failing, a new system is the more economical long-term choice.
A well-installed EPDM, TPO or modified bitumen roof typically lasts 15–25 years depending on the system, the install quality and drainage.
Flat roof replacement in New Jersey typically runs $500–$1,100 per square (100 square feet) for EPDM or TPO, so a typical residential flat section lands around $8,000–$20,000. Drainage fixes and wet insulation move the number. Our new roof cost guide has the breakdown.
Roof estimate

We'll be out very soon.

No high-pressure sales call. You get a clear, fixed written estimate for your roof repair or replacement across northern New Jersey, and a straight answer on what your roof actually needs, backed by our 10-year workmanship guarantee.

Or call us directly(201) 908-0002 Call now